Leaderboard

Hi, I threw together a quick script that allows you to bind two commands (FlyWithLua/SF34/PitchWheel_up and ..dn) to a button that allow you to simulate the pitch wheel in both IAS and VS mode. Minor issue is that the IAS gets changed in increments of 2kts. Solved with update, see below. Feedback is welcome.

Hi Jan, Thanks for the tip! One more observation from the problem is that it's resetting the altitude on the VNAV profile once it passes the WPT. It goes to 0 and then starts decreasing till it reaches next WPT. Hope it will be helpful for the bug fixing in the future

VRAM more than anything.

Would a lua-script help you, that holds the brakes while a button is pressed help you?

Door logic has been recoded. But we'll look into it. Braking is now down to just using datarefs, which means V key for Park brakes and B key for foot brakes. We're looking into commands. The Power levers should work with a regular axis. Nothing was actually changed in that. Have you tried re-assigning an axis? Not aware of this one, and no else has reported this. I just double checked on my system, and sounds are working fine. Perhaps try a reinstall?

In addition to the VNAV work we have also these fixes lined up for the next update: Improvements * Added switch in aircraft file to always force experimental flight model on * Improved tracking ability of nosewheel in tight turns (less skidding) * A "direct to" turn will not attempt to re-intercept the line between current aircraft position and the waypoint * Yoke checklist can now be flipped up and down and yellow bug goes all the way to top again * Added a dataref to indicate if autothrottle is active or not * Added a preference to "pause on Top of Descent" Bug fixes * Fixed right-hand windshield wiper 3D * Fixed fuel gauge testcycle * Fixed leading-edge devices lighttest button * Fixed EGT needle on steam gauges not going higher than 800C * Fixed hydraulic accumulator pressure on modern gauges always showing full pressure * Autopilot trim cutout switches will now also stop the speed trim * Scavange pump will not trigger unless a center-tank pumpswitch has been turned on then off * Animated stopwatch buttons * Vertical speed scrollwheel can now turn "infinitely" (instead of running against an invisible turn limit) Cheers, Jan