Leaderboard

Use the LSK L1 (first line) as the FROM.

Thank you @OuterMarker

We are looking into this for a fix for 1.1.1

I found I asked a silly question here. Today I found Warthog throttle "reverse thrust key press" matches XP default "hold Max reverse thrust" . so axis for reverse it a good option Why I pay hours to find a reverst thrust because "reverse thrust animation" in IXEG comes with a little delay. it makes me to think reverse thrust didn't work

I hesitated to buy IXEG, because as we all know, we have ZIBO 738, FJS 732, FF 757/767, why bother to buy 733 from IXEG? Until XA has a discount of IXEG recently, combining IXEG team has a promise of a update of XP12, I bought it in. Suprisingly, it is the most VR playable Boeing aircraft, meaning it is FPS friendly enough, at least my PC can achieve +30fps in HP reverb G1 VR. someone might say ZIBO, not on my PC, it is less then 24fps, FJS is struggling with 24 as well, FF is a fps killer because of SASL. I understand non-programmers won't care too much about FPS, they just want more FPS, but they really don't care FPS. as a programmer, I understand FPS means good software architecture, it turns out only a couple of FPS, but cost brain more. so I will say IXEG is a good team, has protential to create better product

The aircraft has "acceleration" on the knobs which is also in the simulation - effectively the faster you spin the knobs the bigger the steps are. This was changed in one of the later versions, so hopefully the behaviour is now better for hardware users. The model is not likely to be modified to support a 1000/100 mode of operation, as it's not how the real aircraft is built.

Not sure if this one was already published. If it was I will remove this post. I found the attached table from the ORM very useful

It's hidden in the "Route Menu": Press the IDX key, enter the Route Menu, select FPLN Wind Update and press Send. Downloading the winds will take a while but eventually you will get a pending flightplan modification which adds all leg winds; confirm via exec and it's in.