Leaderboard

Thx Saso...I saw it in the dataref list and set it to 1, but it was immediately set back to zero so I didn't realize if it worked or not...I wasn't paying attention to the lighting..just 'poking around'. Certainly if its beneficial during the act of changing a lighting setting, then we'll put it in asap. -tk

Proud new Moo owner here. First off, I am still in XP11. I was under the impression that the latest installer will detect this correctly and install 2.0.4, however the version file in the aircraft folder shows 2.1.0. FYI. The issue I am having is that the HSI CDIs (both sides) are not responding correctly to any of the RXP units when the CDI mode is set to GPS. Ground-based navigation is working as far as I have tested (briefly). I have tried all-GNS and all-GTN configurations. The deviation bar does not deflect (except during the initial test where it correctly shows half-left). During the test, the CDI course also sets itself to 150, but it does so regardless of my auto-slew preference on the RXP menu. After continuing past the test page, the course re-sets to an arbitrary value (024 or something, already forgot), and will be frozen. Rolling the course knob increments the digital readout but not the needle. Also, FYI, I didn’t touch any of the shipped GTN/GNS.ini settings at first, but I did check them while troubleshooting.

I'm unsure as of this very instant. There are some unknowns I need to get more info on, but am currently focused on the dev work atm so I haven't thought about it terribly much. Certainly we'll be working towards that native support asap and I expect I'll probably turn my attention to that in about a week or so as part of our final punchlist and QA work before deployment. -tkyler

BN-2 updates are almost complete so those should be coming out soon. No exact ETA though.