Leaderboard

The graphic below shows an "upper limit" and "lower limit" value for users to tweak their tolerance zone for when they want to lift the levers. These are not %, but a ratio from 0 to 1, with flight idle point being at 0.5. So a nominal tolerance zone might be a lower limit of 0.45 and an upper limit of 0.6. Of course I'll document this before the update. -TK

hope this plays. last one was encoded wrong. this is H.264. In this video, When moving the levers UP in BETA...I am "holding down" the lift levers command to illustrate how it only lifts and "captures" when in the zone. (though I screwed up, leaving the pref window "in focus" for a bit before I figured it out.) levers.mp4

so FYI....if my logic with my planned fix is flawed. let me know if I'm missing something. When the "lift both power levers" command is executed....then I test for 3 hardware axis values.....the single throttle, the left and the right. and if ANY of these axes are wihtin the tolerance zone, then the lift both command will lift both levers. Previously, I only checked the single paddle (THROTTLE) hardware axis...since the "both" was originally intended for just single throttle paddles. Now that's not the case. This should allow you to hit the one button on the Bravo and move either lever.