XST Posted July 17, 2022 Report Posted July 17, 2022 Landing V2: torque doesn't go lower than 60. Then beta and reverse. Makes me difficult to control normal speeds for landing with min torque at 60... it is not happening to me in v1. Am I doing something wrong? Thanks!
Ch.Cole Posted July 18, 2022 Report Posted July 18, 2022 Does the lever in the sim move normally? What type of hardware do you use? What's your power lever detent set to in the MU2 preferences? How does your axis curve look? It sounds like maybe the detent ratio and the curve do not match
XST Posted July 18, 2022 Author Report Posted July 18, 2022 Solved. The axis curve configuration was not stored correctly. I fixed it again and not works. Sorry for inconvenience.
tkyler Posted July 18, 2022 Report Posted July 18, 2022 (edited) 4 hours ago, XST said: Solved. The axis curve configuration was not stored correctly. I fixed it again and not works. Sorry for inconvenience. FYI XST, I am changing the hardware configuration for the next update......no reponse curves needed....BUT it will operate exactly the same as it does for you now with the response curves. FYI.. So easier setup, same operation. Edited July 18, 2022 by tkyler
XST Posted July 18, 2022 Author Report Posted July 18, 2022 11 minutes ago, tkyler said: it will operate exactly the same as it does for you now with the response curves. FYI.. So easier setup, same operation. Good! I will remove curve settings on next update. Thank you!
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now