Gizmo Error

[jmf55]

I get the attached Gizmo error. Fresh startup of X-Plane. I click Clear & Reboot and it appears to fine after.

Just wanted to pass this on in case it may be an issue.

[tkyler]

usually see that one when relocating or reloading with sim paused?  anything like that?  

[jmf55]

No Sir. It was a total fresh start of x-plane. Come to think of it, I did have a couple three instances whereas x-plane didn't shut down and I forced it. These may/probably caused the Gizmo error since I later went back in and solely brought up the MU-2.

Edited July 18, 2022 by jmf55

[tkyler]

well..I should have clarified...its at "load of the airplane", whether first start, reload, relocation, etc..  I suspect you could simply go "change location > new flight" and it probably wouldn't appear again.  just the same, I'll track this.

Thx

[jmf55]

I'll pay more attention if there is a next time. If x-plane won't shut down after flying this beautiful aircraft and I do an end process, I'll make note of it. I will then fire up x-plane and the MU-2 and see what I get.

[Ben Russell]

Force quit is unlikely to cause this. 

[jenijek]

Greetings! I think that you need to re-install the plane + Gizmo plugin and reactivate all crafts that work through Gizmo online. You must be connected to the Internet

[mjrhealth]

I have same issue, And no dont need to reinstall gizmo or plugin. This with 5 Blade glass and with OEM ver. When starting xplane and resume fight. Not if you change planes. Restarted xplane with LES SAAB, no issues,

Loaded MU2 , no issue,

Restarted XPLANE and resumed with MU2 and it shows up.

Loaded a non Xaviation plane and restarted xplane. resumed with non xaviation aircraft.

Loaded Mu2 and it loaded fine

So its only a a restart of xplane and resume with MU2 it shows.

So it seems after a few restarts. May be a timing issue

[mjrhealth]

To add to above, if you reboot the console  the error clears

[Ben Russell]

Rebooting the console will reload all the scripts and is basically a clean slate as far as avionics systems goes. Good on the ground, parked. Bad in the air with engines running. 

I'll see if I can work with Tom to resolve this.. 

[dkieres]

I am getting the same gizmo error, but additionally (and perhaps, related) my MU-2 preferences are not being saved.

Dave

[Ben Russell]

I've looked into this for Tom and made a recommendation on how to fix it. 

For now you should be able to safely ignore the error by simply closing the console window. 

Systems functionality shouldn't be degraded if this error occurs. 

Edited July 21, 2022 by Ben Russell