[SOLVED] Reversers dont stay on

[Rhinozherous]

Hello!

I use the Bravo Throttle and have the button on the throttles bound to "Hold thrust reverse at max".

After landing they activate when I push it, but after a few seconds they deactivate without me doing anything... No matter if I stay in idle thrust or if I increase thrust during rev active.

Edited January 9, 2022 by Pils

[Pils]

If you’re holding max reverse why would you be moving your thrust levers? You’re already at max. Stow the reversers and then you can move to forward idle. Each cycle of reversers takes time. A video of your issue may help diagnose. Thanks.

[Rodeo]

Hold reversers at max: reversers are only held while the command is active, so presumably you must keep your thrust levers full back (including the notch which IIRC exists on the Bravo). Otherwise you should assign toggle thrust reversers instead…

[Ed Moore]

I’ve got the Bravo and I found it worked better to use an axis specifically for reverse, then you have all the control you’d want.

I have my axes L to R as:

Speedbrake

Reverse

Eng 1

Eng 2

<not used>
Flaps

[Rhinozherous]

5 hours ago, Rodeo said:

Hold reversers at max: reversers are only held while the command is active, so presumably you must keep your thrust levers full back (including the notch which IIRC exists on the Bravo). Otherwise you should assign toggle thrust reversers instead…

I think I confused the assignments... I thought "hold at max" is the right one... I will now use "toggle"! 

Thank you guys!