txnoodles Posted July 31, 2020 Report Share Posted July 31, 2020 I have problems on take off.Even if the sr22 is trimmed for take off the plane balloons up as soon as I take off and banks slightly left.Trimming the ailerons is even worse because I can't get the top edge lined up with the zero.It's hard to see. Any hint or tip ? Thanks Quote Link to comment Share on other sites More sharing options...
Pivot Posted July 31, 2020 Report Share Posted July 31, 2020 To keep wings level, be sure to keep an eye on your rudder trim. This goes with pretty much, any change in power during flight. Quote Link to comment Share on other sites More sharing options...
Aleksandar Posted October 19, 2020 Report Share Posted October 19, 2020 (edited) Start to slowly rotate just before reaching 70 and the climb out will be smooth. Banking slightly left is normal, especially on a high-torque engine. When you use rudder to accellerate down the runway, you may find that just a bit MORE rudder is used when you rotate due to gyroscopic precesssion. This is a well balanced behavior compared to many addon models I have. Also, don't forget to consider wind effects. Edited October 19, 2020 by Aleksandar Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.