trim trim and trim

[txnoodles]

I have problems on take off.Even if  the sr22 is trimmed for take off the plane balloons up as soon as I take off and banks slightly left.Trimming the ailerons is even worse because I can't get the top edge lined up with the zero.It's hard to see.

Any hint or tip ?

Thanks

[Pivot]

To keep wings level, be sure to keep an eye on your rudder trim. This goes with pretty much, any change in power during flight.

[Aleksandar]

Start to slowly rotate just before reaching 70 and the climb out will be smooth.  Banking slightly left is normal, especially on a high-torque engine.  When you use rudder to accellerate down the runway, you may find that just a bit MORE rudder is used when you rotate due to gyroscopic precesssion. This is a well balanced behavior compared to many addon models I have.  Also, don't forget to consider wind effects.

Edited October 19, 2020 by Aleksandar