Xplane 11.30 b2

[kjhkent]

Just a heads up. I appreciate its a beta but 11.30b2 breaks the TBM. It will load but the side buttons for air frame, maintainence etc are all over the place and not easilly selectable. I am reverting back to 11.30 b1 where I personally had very few issues.

[cpuwolf]

as far as I know, beta will not be supported by any aircraft manufacture.

[kjhkent]

15 minutes ago, cpuwolf said:

as far as I know, beta will not be supported by any aircraft manufacture.

I know. Not expected.

[sdflyer]

Just a heads up. I appreciate its a beta but 11.30b2 breaks the TBM. It will load but the side buttons for air frame, maintainence etc are all over the place and not easilly selectable. I am reverting back to 11.30 b1 where I personally had very few issues.

That what I had in 11.26 with scaling anything other than 100%


Sent from my iPhone using Tapatalk

[sd_flyer]

FYI I just install 11.30b2 and o problem with the menu. As i suspected it's probably the same issue with scaling as it was upon release - anything above 100% get menu screw up

[deimos256]

Not sure if it's related but after updating to 11.30b2 I ca'n't get the plane started anymore.  I move the throttle out of cut-off and get a warning about fuel residue, replace the part, try to start again, same result.  

[kjhkent]

1 hour ago, deimos256 said:

Not sure if it's related but after updating to 11.30b2 I ca'n't get the plane started anymore.  I move the throttle out of cut-off and get a warning about fuel residue, replace the part, try to start again, same result.  

Make sure that the red manual overide lever is fully forward. 

[Smiley0201]

Red lever must be fully backwards, not forward.

Full forward will introduce fuel and flood the engine in no time...

[kjhkent]

12 minutes ago, Smiley0201 said:

Red lever must be fully backwards, not forward.

Full forward will introduce fuel and flood the engine in no time...

Thanks for the correction.