Soft Crash 1.0.3 FMC/CDU when Programming Altitude

[Torbinator]

 Hello, I hope the attached files and description helps find the issue I had.

 I'm using the Navigraph 1605 ARIAC with the v1.0.3 733.

Ran a C&D start, then started entering in the usual steps with the CDU.

Entered the following airports: KPSP to KONT, then routes page entered MORON V137 ARRAN V8 PDZ, then approach page ILS 26L and PDZ transition.  No DISCOs.  Went on to PERF INIT, plugged in 88.2 ZFW, 1 for the reserves, then when I entered the altitude of 10,000 it soft crashed.

I repeated this three times in a row before picking a different route. Twice on C&D start, and the third was in turn-around mode.

For future reference, are these screenshot of any use when the debug file is successfully created?

IXEG_debug_01.txt

Edited May 19, 2016 by Torbinator

[Torbinator]

 A brief follow-up, I just tried the same route again. However, I did the PERF INIT first.  It took the 10,000 foot altitude fine. Then I put in the location, destination, and the routing. It was the moment where I went to execute the route where I got another soft crash. However, as you can see by the screenshot it did not allow me to export.

[Litjan]

Yes, we found out that there is a problem with cruising altitude 10.000 (as this is also the speed restriction altitude). We will fix this, for now you can avoid this by cruising higher or lower.

Jan

 

[Torbinator]

Interesting.  Thank you.

[tkyler]

This looks to be fixed in the next hotfix, due our shortly.

-tkyler