jason74

It might be complex but its taken far too long , its not like XP12 is a completely different sim from XP11

Hi just wanting to know if the G500 will be updated for when the MU-2 becomes XP12 Compatible?

Hi just wanting to know?

HI your SR22 would be great in MSFS and would sell like hot cakes. Any plans for a future MSFS release?

same problem patch not working

I average 40 FPS in Xplane 11. If i enable Skymaxx my frames never go past 20 FPS and get as low as 6 FPS in cloud. Not happy with the product its not usable without ruining the whole flight experiace. I run it in a RTX 2080 TI

not happy that i just purchased SkyMaxx Pro V4 on the 8th January. . If i new V5 was coming out i would have waited.

Thanks for your help

I'm going to do a fresh install of x-plane , if I do it now I can let it download over night and let you know tomorrow!

Log.txt I removed all 3rd party plugins, except Gizmo, and reload the sim, press the red button...twice, then close the sim here is the log text.

look ill do a new install of Xplane and plug ins and then we can see if it fixes the issue or if it happens again.

sure here you go ! TBM900_Log.txtLog.txt

TBM900_Log.txt

I also use xOrganizer but have removed that also

I use Honeycomb bravo throttle light switches . I disconnected the Bravo throttle and Saitek yoke. I removed all plugins also but still its not working. I then assigned a button on my yoke for the Display Backup Button but no luck with that. Are there any hidden folders I can remove so I can do a clean install so it wont remember the history and be like a first time use?

Hi I'm having an issue with the Display Backup Button. I pressed the button while I did an engine start but now its stuck on the backup screen. The red button no longer works. I have tried new airframes and aircraft locations but I still get the backup screen as soon as I power on the aircraft. I have also done a full aircraft re-install but it still remembers when I turn the Power on it goes into the backup Screens. Regards Jason

when i look at my flight plan there is no route discontinuity in it. it shows the TC and TD. I just tried another flight and vnav works. sometimes it works others it does not. I always check my flight plan is entered and complete. I have been flying the PMDG NGX for years so know how to enter the flight plan. I do understand the IXEG 737 vnav is a little differant to the NGX

Yes I have star and runway selected for the destination and i hand fly the 737 up to 1000ft before pressing Vnav

Hi Im having problems with vnav. If I start my flight in Turn around mode once I take off on my flight vnav will not engage. If I start my flight with engines running vnav works. I do arm the auto throttle and FD and once the power gets to about 40% I press the toga switch. is there a switch on the overhead panel im missing?