[1.0.2] Persistence Issues

[daemotron]

I'm observing a few smaller issues with persistence:

• While all covers, tie-downs and chocks are usually (re)stored as I left them, the engine plugs are systematically omitted
• Payload and fuel is a hit and miss, sometimes it's restored, sometimes it isn't (seems like it's stuck with a very old state which it reloads over and over again)
• Same goes for the headset; I always remove it after a flight, but there's a good chance it's back when reloading the aircraft

Would be great if these could be fixed; e.g. by providing a menu "store this state", forcing to write the current state (if XPs shutdown process isn't reliably triggering the save state function or not leaving enough time for it to finish what it's supposed to do).

[ghostpilot]

I have a similar problem, but sort of the opposite. The aircraft spawns in the state I left it even though I have "Enable Persistent Systems" checked off in the main menu.

 

[Coop]

9 minutes ago, ghostpilot said:

I have a similar problem, but sort of the opposite. The aircraft spawns in the state I left it even though I have "Enable Persistent Systems" checked off in the main menu.

 

Do you have "start with engines running" selected in X-Plane? That will bypass any persistent bits.

[ghostpilot]

33 minutes ago, Coop said:

Do you have "start with engines running" selected in X-Plane? That will bypass any persistent bits.

No, that's checked off. When I spawn into a new flight, the engine is off but the switches are all in the position I left them in previously.

[RMNJr]

Having the same issue with persistence. It seems to just load the default config every time.