G500 baro setting (solved)

[MSFS Ralf]

How to switch from IN to HPA? I found „System Units“ under „AUX“ but can’t change it.

Edited May 29, 2023 by Ralf Maylin
Solved.

[Coop]

Press the right side knob to get the cursor to show, then rotate the outer knob to highlight the Pressure section. Once there, use the inner knob to change the value. When HPA is selected, click "ENT" to set it.

[MSFS Ralf]

Thanks a lot. I cannot push that knob with the mouse. Mapped to hardware, works great now.

[tkyler]

1 hour ago, Ralf Maylin said:

Thanks a lot. I cannot push that knob with the mouse

Presumably on the MU2?    This is an oversight on my part and fixed for the next MU2 patch (for those concerned)

-tkyler

[MSFS Ralf]

3 minutes ago, tkyler said:

Presumably on the MU2?    This is an oversight on my part and fixed for the next MU2 patch (for those concerned)

-tkyler

Yes, the Moo Two. No problem though. Thanks for that great plane.

[fleurenf]

On 5/30/2023 at 3:03 AM, tkyler said:

Presumably on the MU2?    This is an oversight on my part and fixed for the next MU2 patch (for those concerned)

-tkyler

Greetings, see my post as well.

Edited July 17, 2023 by fleurenf