TBM900 MFD Charts - How to select Airport?

[pegruder]

Hey all quick question - how does one change what airport is selected on the charts page on the MFD?  Im always able to pull up the departure airport, but if i want to change to the destination airport I can't seem to figure it out.  I figured itd be as simple as dialing in the ICAO code but then the airport doesn't change, tried pressing enter ect, but nothing.

[oldflyguy]

Hi @pegruder!  As I recall just move the cursor up to the airport identifier line and enter the new airport code.  I will take a look later today to confirm - and remember LOL.  Never had an issue with this.

[pegruder]

Thanks @oldflyguy.  I enter the new code, but it never seems to update what airport is selected.  Funny I tried it just now on the ground connected to the GPU and it was fine.  Ill have to try it again mid flight and see what it does.  It seemed very simple so not sure what I've been doing wrong.

[mrogers0547]

In flight I think it's the destination airport if a flight plan is active.