zoltron_rulez Posted May 10, 2015 Report Share Posted May 10, 2015 (edited) All, I have the following dataref that I want to write but the value is ignored: sim/cockpit2/autopilot/heading_mode I try to write a value of 1 (int), but X-Plane ignores it. I tried writing to using dataref editor, same thing. How is this dataref set (for heading hold)? **********UPDATE:OK, I found out that I cannot write to this dataref, neither to this one (sim/cockpit2/autopilot/altitude_mode). Therefore, the question is, how do I control the MCP, what dataref, I cannot seem to find it. Thx, z Edited May 10, 2015 by zoltron_rulez Quote Link to comment Share on other sites More sharing options...
zoltron_rulez Posted May 10, 2015 Author Report Share Posted May 10, 2015 (edited) Deleted **** see above. Edited May 10, 2015 by zoltron_rulez Quote Link to comment Share on other sites More sharing options...
JGregory Posted May 10, 2015 Report Share Posted May 10, 2015 Use the command system Quote Link to comment Share on other sites More sharing options...
zoltron_rulez Posted May 11, 2015 Author Report Share Posted May 11, 2015 (edited) Thx Gregory, - I will give it a try. ********* Update: It worked. z P.s. Just spent reading info cmds vs datarefs from Ben's blog,- it answers a lot my questions. Edited May 12, 2015 by zoltron_rulez Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.