No LOC and GS when on ILS APP on IXEG B733

[rafaromanosp]

Hello guys,

Recently having an issue with my IXEG B733 where i dont have my LOC and GS indicators alive, like if the aircraft had an ILS receiver failure.

Any fixes regarding this?

Best regards,

Rafael

Edited Friday at 01:54 PM by rafaromanosp

[Litjan]

No, it works fine on everyone else´s installation - it must be something you are doing wrong. Also check if you have the default random failures on, there IS a chance for them to fail your nav receiver or even the ILS transmitters randomly.

[rafaromanosp]

Hello, after performing a clean installation the aircraft works correctly on the first run. However, once I close and reopen the simulator the issue returns. I’ve checked the random failures settings and none are active. Ive tested other aircraft and they work as intended.

[Litjan]

This is strange - does this only happen at one airport or at several?

There is always the possibility that other plugins interfere (fly with lua, etc.) if you could attach the log.txt file from a run where the ILS did not work, I could take a look.

Also, try to post a screenshot that shows the Mode Control Panel (where you set the ILS course) and the VHF NAV radios (where you set the ILS frequency).

[rafaromanosp]

I ran three additional test sessions with the aircraft at different airports and everything behaved as expected. The only change on my side was removing the custom liveries I previously had installed. I’ll continue testing, and if the issue reappears I’ll attach the corresponding log file here.

[Litjan]

Thanks for reporting back...I really don´t know how a livery could affect the nav-radios. 

There is also the chance that you have the "disable downwind ILS" function enabled and if the wind shifts, the ILS signal will turn off for the downwind runway...