The throttle does not work

[eomer]

I can't move it with F1 or F2, or with the joystick controller. With the mouse does not work either
With the rest of the aircraft it works normally.

 

Edited May 20, 2023 by eomer

[MANOLO]

Read the manual.

You must assign to Throttle 5

[Cameron]

18 minutes ago, eomer said:

I can't move it with F1 or F2, or with the joystick controller. With the mouse does not work either
With the rest of the aircraft it works normally.

 

https://www.togasim.com/mu2docs/setup/hardware_setup.html

[eomer]

 

These are the commands that are assigned.

The commands indicated in the html manual can not be found in the keyboard configuration, anywhere:

sim/engines // throttle_up  (F2 key by default)
sim/engines // throttle_down (F1 key by default)
sim/engines // prop_up (F4 key by default)
sim/engines // prop_down (F3 key by default)
xscenery/mu2b60 // lift_condition_levers
xscenery/mu2b60 // condition_levers_to_EMERSTOP 
xscenery/mu2b60 // toggle_emer_stop
xscenery/mu2b60 // condition_levers_to_TAXI

xscenery/mu2b60/toggle_both_emergency_stop          //  toggles both levers between EMER and TAXI
xscenery/mu2b60/both_condition_levers_to_EMERSTOP   //  commands both levers to the EMER STOP position
xscenery/mu2b60/both_condition_lever_to_TAXI        //  commands both levers from EMER back to TAXI

 

1 hour ago, MANOLO said:

Read the manual.

You must assign to Throttle 5

What is Throttle 5? I don't understand what you're saying.
Could you explain it in more detail please?

 

[Cameron]

25 minutes ago, eomer said:

What is Throttle 5? I don't understand what you're saying.
Could you explain it in more detail please?

You mentioned a joystick, so that's why you were told this. It sounds like you're wanting control via keyboard or mouse though (F1 and F2 do work to advance power).

That said, move your mouse to the right of the sim window and click the red Mitsubishi icon that flies out from the side of the window. Then, make sure "Manips with Hardware" is checked.

[eomer]

Thanks

[MSFS Ralf]

I have a throttle question as well. Using the Honeycomb Bravo, I followed the manual and set up throttle and prop levers. But I can’t move the throttles to ground idle, and the reverse command does not work.

[Cameron]

4 hours ago, Ralf Maylin said:

I have a throttle question as well. Using the Honeycomb Bravo, I followed the manual and set up throttle and prop levers. But I can’t move the throttles to ground idle, and the reverse command does not work.

https://www.togasim.com/mu2docs/setup/hardware_setup.html#honeycomb-bravo

 

Pay attention to the lift command.

[MSFS Ralf]

Many thanks Cameron. That lift command was missing.