No animation and sound of lever lifting in the PROP axes

[Bulva]

I mentioned it in passing in another thread, but I will remind you in a this thread so that the topic does not escape from the new update.

If I am using the mouse to move the PROP lever then everything is OK - i.e. below the TAXI value, you hear a sound and you can see the lever go up.

If I use the assigned PROP axes (to my Bravo), the levers only shift - i.e. they go below the TAXI value, but without the visual animation and the sound of lifting the lever.

 

This is what it looks like when I use the mouse:

 

... and this is what it looks like when using Bravo:

 

 

 

Edited August 7, 2022 by Bulva

[tkyler]

post reponse curves for the prop axis please Bulva.

Edited August 7, 2022 by tkyler

[Bulva]

I use the recommended curves. but i tried other settings as well.

[tkyler]

@Bulva somthing is funny.  See below screenshot.

On the left is my mapped hardware axis value is 0.08, exactly as shown in your response curve screenshot above and validated by dataref editor output..  For this prop1 hardware axis value of 0.08 (8% of overall prop RPM range), then the resulting prop rotation speed should be between 114-115 rad/sec....and the 3D lever is animated based on the RPM setting (not hardware position) and should just align with the TAXI mark at this (0.08/114.7) value pairing.  The 2nd screenshot at the right, shows a non-adjusted response curve, 0-1...and an axis value of 0 (lever fully aft)...and the 3D lever is now below the line as expected in this case..its lowest possible position with a hardware axis.    The only way for me to confirm your full setup is for you to send a similar screenshot. In the end, we're matching numbers to animation so without the numbers, I can't tell whats going on.  This is straight up linear interpolation and its working perfectly fine on every axis I try this with.  Your 2nd video suggest no response curve mapped to 0.08 on the low end.

 

Edited August 7, 2022 by tkyler

[Bulva]

2 hours ago, tkyler said:

@Bulva somthing is funny. ...

Now I used the Gladiator joystick (instead of Bravo).
I set: the Gladiator's axis as PROP 2.
I assigned a button peden to the command "Move right condition lever to EMER STOP".
The curve is set like this:

It still looks a little different than Yours and still no animation and no lever lifting sound.
In version 2.0.0, the animation of lifting the lever was visible (of course there was no sound, because it appeared with v2.0.1).

Another video:

xsMU2B60_4B_GNS - 2022-08-07 23.53.06.zip

 

[tkyler]

That looks more normal "as far as rotate movement"..which is what I keyed on in my previous response.   Understood on the "no sound and no lift animation"  will look into that.

TK

[Bulva]

Two more screenshots from DataRefTool (although I don't know if it whatever will help  ):