GTN750 Doesn't work

[destefanibr]

I just bought one TorqueSim BN-2T Turbine Islander and its not compatible with GTN750, in NAV mode did not follows the track.

Log.txt

[destefanibr]

On ILS around 3nm from the threshold the acft turn to the left and deviated from the procedure .

Log.txt

[Coop]

From the image included on the support ticket you sent, the autopilot was sent to Heading mode. Make sure the GTN CDI is set to GPS, and the Autopilot is set to NAV for it to follow the GTN.

[destefanibr]

It happen on the first flight , and I needed to put it in HDG to perform the flight , the second on ILS I had use it in CDI ILS LOC mode and until 3nm from thsld ok, after that the acft turn left and lost the loc/gs on the short final, I'll perform the same procedure to know what happen again.

 

tks

[destefanibr]

[Angry Goose]

I have been wrestling with mine a bit, finally seem to be getting it after my 4th flight now actually hit the GS on an RNAV and started climbing..., but I don't get a pop out on this plane? 

 

Edited May 1, 2023 by Angry Goose

[Coop]

15 hours ago, Angry Goose said:

I have been wrestling with mine a bit, finally seem to be getting it after my 4th flight now actually hit the GS on an RNAV and started climbing..., but I don't get a pop out on this plane? 

 

Popouts can be opened from the RXP GTN menu under plugins.

Regarding the glide slope, the airplane will just follow what the GTN sends to the HSI. What was the HSI showing for the glideslope indicator?

[Angry Goose]

Not sure, trying again tonight for the Rnav, but I went to the plugin, cant find how to get the pop out I get on other planes with a right click...aaand it reset properly now so nvm....

 

Edited May 2, 2023 by Angry Goose