destefanibr Posted June 16 Report Share Posted June 16 I just bought one TorqueSim BN-2T Turbine Islander and its not compatible with GTN750, in NAV mode did not follows the track. Log.txt Quote Link to comment Share on other sites More sharing options...
destefanibr Posted June 16 Author Report Share Posted June 16 On ILS around 3nm from the threshold the acft turn to the left and deviated from the procedure . Log.txt Quote Link to comment Share on other sites More sharing options...
Coop Posted June 16 Report Share Posted June 16 From the image included on the support ticket you sent, the autopilot was sent to Heading mode. Make sure the GTN CDI is set to GPS, and the Autopilot is set to NAV for it to follow the GTN. Quote Link to comment Share on other sites More sharing options...
destefanibr Posted June 16 Author Report Share Posted June 16 It happen on the first flight , and I needed to put it in HDG to perform the flight , the second on ILS I had use it in CDI ILS LOC mode and until 3nm from thsld ok, after that the acft turn left and lost the loc/gs on the short final, I'll perform the same procedure to know what happen again. tks Quote Link to comment Share on other sites More sharing options...
destefanibr Posted June 17 Author Report Share Posted June 17 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.