Jason1970 Posted February 8, 2022 Report Posted February 8, 2022 Hello, just wanted to ask , after a long flight , on my descent , I get two yellow warnings on my ICAS, AOA and a Stall fail warnings . I cannot place the covers back on one of the probes, I suspect is the one that’s “faulty” can this be cured during flight ? thank you Quote
ois650 Posted February 8, 2022 Report Posted February 8, 2022 Hello, Is the cover on the alpha vane (exterior below captain side window) in flight? Please attach a log file also. Thanks! Quote
Jason1970 Posted February 8, 2022 Author Report Posted February 8, 2022 Hello, all covers were removed In flight , ( I had done a previous flight from Edinburgh to Southampton without issues, 20 minutes on ground and after flew from Southampton to Gibraltar ) what I did notice was that after landing it doesn’t let me put a cover on one of the probes . So I left it off overnight . will check tomorrow when I restart , I am hoping the warning has gone ? Quote
hikariken Posted February 13, 2022 Report Posted February 13, 2022 hi I have the same issue now and then when doing a multi leg flight or encountering icing conditions Left AOA heater and stall fail cas. I checked the failures and none are triggered. no pitot cover either Quote
Peter Clark Posted February 13, 2022 Report Posted February 13, 2022 15 minutes ago, hikariken said: hi I have the same issue now and then when doing a multi leg flight or encountering icing conditions Left AOA heater and stall fail cas. I checked the failures and none are triggered. no pitot cover either Curious, any breakers popped? Especially in the panel down by the captains feet? Quote
hikariken Posted February 13, 2022 Report Posted February 13, 2022 (edited) nope. no breaker popped. I have tried resetting the breaker, tried triggering the failure and resetting it. No dice, the cas message remains. in the electrical page of the study panel, the L AOA heater does show 0W and 0A pulled so it does not work, but I have no visible reason for it I had no problem to put the covers at the end of the flight though I use the Ice simulation Lua script though, I'll try removing it see if it might be the cause. Edited February 13, 2022 by hikariken Quote
Jason1970 Posted February 13, 2022 Author Report Posted February 13, 2022 It was back to normal after landing / restart …… issue has not reoccurred.. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.