bludy Posted May 30, 2011 Report Posted May 30, 2011 Hi everyone, I am a fan of this aircraft since day 1, and had been flying it without mayor problems after all, but now with this update it has been imposible to me to engage the AP button after takeoff, making all the same procedures before the update.No one have the same problem? I tested only two times, two airports, nav source to nav1 or fms, from cold start...I will continue testing, bye
X-elbert Posted May 30, 2011 Report Posted May 30, 2011 remember that the YD lights have been reversed, so when they are engaged they are OUT, Not Lit.without the Yaw Dampners engaged the AP will not work, Good Luck
Japo32 Posted May 30, 2011 Report Posted May 30, 2011 yaw dampers are now inverse. If they are illuminated, then they are off. If they are NOT illuminated, then they are on, so Autopilot will work. The info is inside the readme.txt file inside documents, and here in this forum.hope that is your problem.
bludy Posted May 30, 2011 Author Report Posted May 30, 2011 Yes, that was the problem, when starting the process I saw the lights on and though "there were something about yaw dampers in the readme, they must be ON by default"... my fault.Thank you so much
Cameron Posted May 30, 2011 Report Posted May 30, 2011 Yes, that was the problem, when starting the process I saw the lights on and though "there were something about yaw dampers in the readme, they must be ON by default"... my fault.Thank you so muchGlad that sorted it out! This topic is now closed. Have fun!
Recommended Posts