MU-2

[clayrb]

I have activated the license but cannot do anything else. The engines are running but can't operate anything else? It's stuck in 2D view mode?

Any suggestions please?

Thanks,

[FlorianR]

Try posting this in the X-Scenery forum, or contact Cameron on the X-Avitation website. Im pretty sure he checks his e-mails every two minutes  .

[tkyler]

I have activated the license but cannot do anything else. The engines are running but can't operate anything else? It's stuck in 2D view mode?

Cameron will have to verify proper activation...he does sleep and travel occasionally so you might have to wait some hours if that's the case; however, to help diagnose the issue further..a few questions to start.  What do you mean by "stuck in 2D view mode"?  The MU2 doesn't have a "2D mode" as most people know it.....it only has a 3D mode.   Have you tried the 'q' and 'e' keys to change the view? Do the views change?  Try using CTRL-o and see if that puts you in a 3D view that you can control with the mouse or a joystick hat switch.  And finally, are you able to grab and move the throttle levers with the mouse?   and if so, does the torque on the engines rise?

[clayrb]

Thanks for the replies.............dumb me I have too many plug ins activated so that was my problem on the issue of a 2D cockpit. However is it normal to fill out the activation wizard every time I fly? Also the plane banks to the right all of the time? I have calibrated my joystick and check the fuel balance still I can't figure it out?

Any advise would be appreciated.

Thanks,

[eaglewing7]

The banking is caused by the Mu-2's rather aggressive engines, reading the manual you will find that one needs to set the roll trim before takeoff.  Then after takeoff readjust the trim, continuing to do so after every power change, and then before landing.

Roll trim is quite important to the overall stability of this aircraft.

[tkyler]

However is it normal to fill out the activation wizard every time I fly?

Definitely not.  I'll ask Cameron to look into your license status.

[clayrb]

Thanks I would appreciate it if he could help me with my license.........