Compatibility with CHProduct Yoke

[Marcodu68]

Hello,

I just bought this plane yesterday and I have the impression it is amazing but I have a great problem : 

All my commands are effective except one : It is impossible to turn the nose wheel. (Hard to follow the taxiways so !)

It is the first plane with this problem, and I have a lot of planes.

Does someone use a CH Product yoke with this plane ? 

Do you have an idea to solve this problem ?

Edited May 1, 2019 by Marcodu68

[N1K]

Is the nose wheel steering engaged?

 

[Nelson H]

I just purchased the 340 and having the same issue of the Gizmo not showing all the options and being unable to use it to assign the condition levers.    I went into the X-Plane configuration and attempted to assign levers.   Obviously did not do this correctly, as I have the left CL assigned to the number two lever on the CH yoke (mixture?) and the right CL assigned to the number three lever on the CH yoke.    When I start up the plane and push the CLs forward, the fuel shuts off and the engines die.    How can I get both CLs to be assigned to one lever on the CH Yoke, and will this fix the issue of the fuel shutting off when advancing the CLs??

Thanks in advance.

 

Nelson

 

[mmerelles]

20 minutes ago, Nelson H said:

I just purchased the 340 and having the same issue of the Gizmo not showing all the options and being unable to use it to assign the condition levers.    I went into the X-Plane configuration and attempted to assign levers.   Obviously did not do this correctly, as I have the left CL assigned to the number two lever on the CH yoke (mixture?) and the right CL assigned to the number three lever on the CH yoke.    When I start up the plane and push the CLs forward, the fuel shuts off and the engines die.    How can I get both CLs to be assigned to one lever on the CH Yoke, and will this fix the issue of the fuel shutting off when advancing the CLs??

Thanks in advance.

 

Nelson

 

 

if i am not mistaken, via xplane joystick menu:

 

SINLGE USER LEVER: assign your desired hardware lever to -prop-, this should control both CLs

or

DUAL USER LEVER: assign one lever to prop1 (for left CL) and a second lever to prop2 (for right CL)

 

Always make sure unused hardware axis levers are assigned to NONE!

 

hope this helps