Enter Holds

[Yuriala12]

Hi,

I've been reading the documentation and I can't find the way to enter manual holds into the G1000.

Is there any way?

Regards

[skiselkov]

Manually entered holds aren't supported by the underlying Laminar G1000 yet (it was absent from real G1000 software for a surprisingly long time as well). Until Laminar implement this feature, please use the following procedure to flying manual holds instead:

 

[cpuwolf]

manual hold, inbound nav, outbound hdg. thank you 

[Yuriala12]

Thank you very much. I will have a look!