A/T disconnect on takeoff

[K4bel123]

I don´t know if anyone has mentioned this before but with the new hotfix 1.0.3 I always get a A/T disconnect on takeoff after pressing the TO/GA buttons (mapped on keypad). I can avoid that by not moving my physical thrust levers but I wanna do so for the feeling. So as soon as I move my physical thrust levers forward after pressing the TO/GA buttons the A/T disconnects. This didn´t happen with the previous versions of this aircraft. I also don´t move too far with my thrust levers (I can see that because the virtual ghost throttles are always advanced further than my acutal ones).

EDIT: If I press N1 instead this doesn´t happen.

Can you confirm that the command "autopilot/take_off_go_around" is the right one to be mapped?

Edited May 10, 2016 by K4bel123

[Litjan]

You might be triggering the "rejected takeoff" mode. We made the autothrottle disconnect if you pull the throttles back during takeoff - so that you can stop if you have to. If you have a spikey joystick or move it back and forth during the takeoff run, this might happen.

Try to push the throttle all the way forward while the autothrottle still advances the thrust levers, and see if that helps? We havent changed any logic related to that between 1.0.2 and .3, though.

Jan

 

[K4bel123]

Thanks for your quick response, Jan. I remapped the command and now it seems to be working again. I will test it though because this is kinda strange