Search the Community
Showing results for tags 'Avionics'.
Found 4 results
-
This might be a stupid question but while flying in cruise I stepped away for a minute from the flight deck ... talking to the passengers ... when I came back I saw that COM 2 and NAV 2 frequencies are crossed out in the PFD and COM2 also in the middle screen. I thought there might be a defect which would be odd after just 18 hours of flight but maybe its a monday model. After landing, I checked the maintenance hanger but every part of the avionics is "as new". Am I doing something wrong here? Thanks in advance for any hints.
-
Hi I have just installed the TBM900 and upon power up & start the MFD is opening with the checklist page and I cant seem to get into any other page, including the map page. Even holding down the CLR key doesn't default to the map page. I'm probably overlooking something and any help would be very much appreciated. Thanks in advance. Strumpy
-
Hi everyone, I just wanted to say first off that I'm loving this airplane. The sounds, the 3D cockpit, the detail with systems modelling is all very impressive. I'm still learning this airplane, so forgive me if this question is a little premature, but when I tune to any ATIS frequency on my COMMS panel, I don't get the text or audio of the weather. I went through the checklist a few times, I made sure to reset the generators before switching them to on, and all avionics switches are on. All lights on the overhead are extinguished. I made sure to make the frequency I tuned active as well, obviously. Does this work fine for everyone else? The frequency I tuned to was from Lihue airport, Kauai. 127.2. I tried it in the Bell 407 and the frequency works. Anyway, any help would be appreciated! Thanks, Kris
-
Hi there, ok do me a favor and try out the following: May be you could also reproduce the problem with your current installation of X-Plane but I just made sure it was not anything else that was causing this strange behavior. - Get a brand new installation of X-Plane 10.5r1(can be also the Demo) - install the CRJ 200 1.4.5 - start X-Plane - after you see the inside of the default B747, wait for 10-15 seconds - bring up the location map and chek out to see if the planes that were on the ground together with you have moved. There should be a small purple line showing the path they have travelled since start. It should be visible. - now load the CRJ and then quit X-Plane so it would be loaded the next time we start the sim - start X-Plane and wait for 10-15 seconds - I do not know what you will see, but I do not see any planes on the ground moving, only those that are in the air have a purple line aded to them. What I noticed is that if I disable the CRJ Avionics plugin and reload the AI planes they immediately start moving, and afterwards if I try to reenable the plugin again X-Plane crashes. So to wrap it up: CRJ is loaded and the Avionics plugin active - no ground AI movement CRJ is loaded and the Avionics plugin disabled - ground AI movement present Any other default XP10 plane is loaded and the plugin active or disabled - ground AI movement present I know that ATC is work in progress, but I still enjoy it when flying planes other than the CRJ. I hope there is a workaround for me here. I am currently using X-Plane 10.05r1 and CRJ-200 1.4.5 under Windows 7x64
