aeropilot

South African Air Force C185 #715 "Sandra" View File South African Air Force "Sandra" 4K livery for Carenado's C185 My last livery in my painting frenzy (I hope). SAAF C185 #715 is nicknamed by 44 Sqn as "Sandra" apparently as a tribute to Lt Gen Roelof Jacobus Beukes' wife. Who is Sandra Beukes? No idea. What happened to her? No idea. Who is Roelf Beukes? Important enough for a short wiki page, he was once chief of the SAAF until 2005. Why is the plane known by 44 sqn as "the little aircraft with a big heart?" No idea. That's all the info I got from a very obscure 2005 copy of a SAAF's Ad Astra magazine, Wikipedia, and whoswho.co.za This was a rather hard livery to make due to since I'm a beginner, but I think it turned out ok. But if there are any problems please tell me! To install, just open the zip and drop the folder inside the liveries folder. The textures are 4K so they only work with X-Plane 10. If you haven't already, get my 10 SAAF bare-metal liveries (#729, #730, #748, and #753) here! There you can also learn about my story of how I accidentally painted the entire photographed non-camo fleet of SAAF's C185s. Also, check out my 4 SAAF red-stripe liveries (#731 and #747) here. Hope you enjoy Submitter aeropilot Submitted 07/08/2016 Category General Aviation Livery For http://www.carenado.com/CarSite/Portal/index.php?accion=product&correl=49 X-Plane Version(s) X-Plane 10  

South African Air Force C185 Red-Stripe Liveries View File 4 South African military red-stripes 4K liveries for Carenado's C185 After I finished painting the bare-metal SAAF liveries, I decided to paint #747 and #731. This is my first time making a livery with stripes, and it was a bit of work to get the stripes aligned. The livery actually exceeded my expectations, but if there are any problems you find, please tell me!! Liveries included are: SAAF ZS-JLY Before Dec 7th 1981 SAAF #731 (ZS-JLY was re-registered to #731 on Dec 7th 1981) SAAF ZS-JLX Before Dec 7th 1981 SAAF #747 (ZS-JLX was re-registered to #747 on Dec 7th 1981) The liveries may look the same, but #747/ZS-JLX features the 44th Squadron Springbok insignia and some sort of cover over the passenger door. To install just open the zip file and drop the contents into the liveries folder. The liveries are 4k so they only work with X-Plane 10. If you haven't already, get my 10 SAAF bare-metal liveries (#729, #730, #748, and #753) here! There you can also learn about my story of how I accidentally painted the entire photographed non-camo fleet of SAAF's C185s. Also, check out the SAAF "Sandra" twin blue-stripe livery (#715) here. Enjoy Submitter aeropilot Submitted 07/08/2016 Category General Aviation Livery For Click Here For Aircraft X-Plane Version(s)

South African Military C185 Bare-Metal Livery Megapack View File 9 South African military bare metal 4K liveries for Carenado's C185 (and 1 bonus grey livery ) Get the red-stripe liveries for #747 and #731 here, and the "Sandra" #715 livery here. This all started two years ago as an attempt on a single livery. Even though I've never visited Africa, one of my silly dreams is to save enough money to go flying there, so I decided to paint a South African Air Force bare-metal Cessna 185 for my flights in X-Plane. I never painted a livery before or worked with graphic editors, so I had to learn Gimp. I started on aircraft #748 because the clearest image on Google was of that airplane. However, in the last two years I almost gave up because I was distracted by school, and getting the bare-metal to look realistic was impossible. I should not have chosen bare metal for my first livery, or chose a very obscure aircraft in a very obscure air force. Getting enough photo references required extensive digging through the corners of the internet. Last week I tried at the livery again and I decided to multiply a metallic texture layer into the livery. Things looked much better, and once I got the bare metal to look semi-realistic things sort of exploded. When I was finished with #748's current livery (it's now based in Zwartkop's SAAF Museum), I decided, heck, why not paint the 3 other variations of the liveries it wore in the past too. Through the years there were minor variations in the squadron seal, or whether the SAAF Castle was painted on or not, etc. Well, now that I've painted #748, I might as well paint #753, which had red wingtips and spinner and different fonts for its tail number. Then I decided I might as well paint both #729 and #730, because they were similar to #753 with minor variations. Then I decided to paint #711, which had almost the same markings but with a grey base instead. Needless to say, this took way a huge lot of research. I then went on to paint #747, #731, and #715, which are completely different liveries (they look civilian). I'll upload them soon and link them here. So I spent two years trying to paint #748, and in the last three days in a frenzy I painted 14 other liveries of 8 different planes. If that's not insanity I'm not sure what is. Cessna 185A, -D, and mainly -Es were delivered to South Africa in the '60s. During the border wars in South West Africa they were used by the South African Army's 41st and 42nd Army Air Recon Squadron as observer planes to spot and mark enemy artillery with smoke rockets for SAAF's Mirages (fun fact, the Angolans had Soviet Katyushas, which forced the SADF to design the G5 Howitzer). They were based in AFB Rundu, Katima Mulilo, and Ondangwa (Northern Namibia). The planes were originally bare-metal, with "SA LEËR/SA ARMY" written on the side, but the text was removed when the squadron was transferred into the air force in the late 60s. They were repainted in camouflage by the mid 70s, and many served with the South African Police. Then, some were used as trainers for the 84th Light Aircraft Flight School in AFB Ondangwa (so close to the front!) until 1988 before being transferred to AFB Zwartkop. Before retirement in 2006 they were used as border patrol aircraft either at Messina (near Zimbabwe's border) or Macadamia (near Mozambique and Swaziland's borders) for 44th Sqn (since 42nd had been disbanded and incorporated into 44's B flight, with A flight being Bosboks). Liveries included are: #711 SAAF 1968-70s (Light Grey) #729 SA Leër Pre-1968 (Bare Metal) #729 SAAF 1968-70s (Bare Metal) *this plane later crash landed in April 13, 2000 in Mozambique territory, killing 2nd Lt. Andrew Patrick Leith and seriously injuring 3 others. #730 SA Leër Pre-1968 (Bare Metal) #730 SAAF 1968-Jan 25, 1977 Written Off at Musina, Limpopo (Bare Metal) #748 SAAF 1994-1995 42nd Sqd 50th Anniversary 1994-1995 (Bare Metal) #748 SAAF 1996-1998 President's Trophy Air Race (Military Markings Removed) #748 SAAF 2011 Zwartkop Museum Static Exhibit for a pilot's reunion (Red Spinner, Bare Metal) #748 SAAF 2015 Wings Over Zwartkop Airshow, restored to flying status! (Bare Metal) #753 SAAF (Bare Metal, Red Spinner and Wingtips) They look very similar, but each livery is different (which caused a lot of hassle on my part!) To install, just open the .zip and drop the folders inside the livery folder. These are 4k textures, so they only work with X-Plane 10. If I'm not feeling lazy later I might convert them to 2k textures for the folks with X-Plane 9. I'm still not completely satisfied with the bare-metal though, but my skills are still quite limited. I almost thought it was impossible for X-Plane to render bare metal until I saw RocLobster's Bare Metal liveries for the Cessna 170 at the .org, and my eyes popped out of my sockets....RocLobster, you're a wizard. If you are unsure which one to fly first, I highly recommend #748 SAAF 2015 just because I spent the most time on that one Since the total file size is half a GB, if you want to download the liveries individually I made the same entry at the .org but uploaded them in separate zips (taking advantage of their upload size limit ha). Please please please tell me if there's anything I should fix and I'll try to within my abilities. But please be gentle; these are my first liveries! Submitter aeropilot Submitted 07/09/2016 Category General Aviation Livery For Click Here For Aircraft X-Plane Version(s)

Thanks for the quick reply. The weird unicode symbols are actually traditional Chinese because that's the language my computer runs on. It just says, "can't find Windows module...", and its because those files are mean't for 32bit windows, not 64bit, which I have. Turns out, the problem didn't have anything to do with corrupt plugins. I was getting desperate and I suspected X-Plane's rendering settings might be conflicting with SkyMaxxPro's (could be entirely different explanation), so I disabled "draw volumetric fog" and "atmospheric scattering" and voila! everything's fine again, with all the plugins enabled. I'm at 32,000 feet on FF's 777 and everything's a-okay. For now.

I flew an additional flight out of Johanessburg, with SkyMaxxPro and 727 plugins, and no other plugins enabled. Crashed around 20,000 feet. The sky was clear though, almost no clouds. Here's the log. Log.txt

Okay, so I did manage to find an update for NOAA weather, from 1.5.1 to 1.5.9, apparently published 2013? Anyways, the crashes still occurred, so I disabled all the plugins except SkyMaxxPro and SASL and T7 avionics, which the FF 777 relied on. I have the latest version. The first log is my first flight with the updated NOAA weather plugin and other plugins I didn't disable. It says XPLM has crashed. The crash occurred right before I reached 20,000 feet. The second log is my second flight with all python scripts and everything else except T7 avionics, SASL, and SkyMaxxPro disabled. It just says "the application has crashed". The crash occurred after takeoff, at around 5,000 feet. ​Help? Log1.txt Log2.txt

Well that's a bummer. Any ideas how to get accurate high altitude wind data? Things like the jetstream aren't provided by default METAR data. Also, what does this mean, from docromano's log? "1:05:51.774 D/HID: HID Bridge Shutdown----- X-Plane has shut down -----" I get this too sometimes when X-Plane crashes, and other times the Log file just seems to have abruptly been cut off.

Okay, so I had a hunch that there was conflict between the XPGFS NOAA Weather plugin (runs on python) and SkyMaxxPro. I disabled NOAA Weather and everything worked fine without crashing, and I didn't lower any of my rendering settings or remove any addons. However, the conflict never occurred before and I rely on NOAA Weather to get accurate high altitude wind data when flying, and I hope to see this problem sorted out and fixed.

Okay, so recently I've been really frustrated about the latest version of X-Plane (10.31r3) constantly crashing a few minutes after takeoff. I could spend as much time as I want on the ground, but after takeoff,at around 5,000~8,000 feet, X-Plane will always crash. Crash as in the crash-report screen showing up (not hang or freeze). After spending a few days of testing, I've discovered this problem occurs regardless of object density or scenery detail, location on Earth, or airplane I'm flying. Even after running X-Plane's updater twice the problem still occurs as well. After removing SkyMaxxPro (Silver lining and Gizmodo), the crashes stopped. I redownloaded SkyMaxxPro to make sure I have the latest version and installed it. Then, I deleted my X-Plane preferences. Yet, the crashes occur again, always a few minutes after takeoff. SkyMaxxPro worked fine on earlier betas of X-Plane, so I'm not sure what's happening here. The log files doesn't really show anything, but I'm attaching it here anyways. Log.txt GizmoLog.txt

When I started the engines, the fan would start to spin for awhile and then *blink* disappear. The second stage fan, which you can see in the picture, was always there. I think it's time for me to do some animation fixes in AC3D.

So I finally decided to update to version 1.5 The front engine fans of the GE-90 disappears when the engine is running. Not sure if it's just me or for everyone, but I can't find anyone else reporting this problem.