mike306
-
Posts
55 -
Joined
-
Last visited
Content Type
Profiles
Forums
Latest X-Plane & Community News
Calendar
Downloads
Store
Everything posted by mike306
-
where do i set the center of gravity
-
thanks, i have it at 3.0 will try for 5.0
-
after pressing ATS start rolling get to 80 all is ok get to V1 and plane goes 15 degrees nose up and ATS fails. what am i missing on the takeoff
-
RJB4000 where did you find the information about the ground spoilers? Looks like a source that would have more information on how to do things with the CL650.
-
thank you, explains it all!
-
when ground spoilers are set to auto when landing the spoilers do not activate. When I set them to armed they activate on touchdown. which setting is supposed to be set?
-
FYG001 I tried this and i see external ac available but can't activate till after APU off and then wrong checklist started
-
Thank you, I thought having the main Battery on that would keep things going.
-
going through securing checklist I get the audio for the steps on the checklist until step 9 APU GEN off. after switching aPU off the remanning steps 10 thru 18 are not prompted. Action needed are not able to be done.
-
OK neat thanks. this plane has total details, well worth the price.
-
in front of the yoke at the bottom.
-
in front of the yoke at the bottom.
-
Just what does the switch near the yoke on both pilot and copilot do?
-
JUST WONDERING IF YOU HAVE HAD A CHANCE TO LOOK INTO MY PROBLEM "BAD PARS DATA" WHILE TRYING TO LOAD A FLIGHT PLAN?
-
thank you
-
how do you set it manually?
-
I have seen some of the problems with zink and AMD on the forum and the solution is don't use it. My problem is the avionics are dark, i have a intel cpu. Does the answer "dont use zink" apply to intel cpu's as well?
-
Thanks for the come back, i have been looking all over the place for a switch.
-
Securing checklist step 17 "service lights off" where is the switch to turn lights off?
-
Is there a list of what all the options are and what they control on "PFD menu like min while landing in and runway should be visible.
-
thank you very much!
-
Stil trying to load a flight plan from xplane12/output/FMS plans 1. Load Xplane 12 2. Load Pilot2atc 3. Connect Pilot2ATC to the sim 4. Toggle FMC to reset FPLN 5. Select FPLN on FMC 6. Select secondary FLPN 7. Select route menu 8. Select disk route listKMCO-KMIA.fmsLog.txt 9. Load FPLN from the list after 10 seconds get "Bad parse data"
-
It does not cause a crash, FMC shows "bad parse". The flight plan was created by pilot to atc and exported to Xplane ...output/FMS
-
can you see anything that would result in bad parse data with the flight plan attached?? KMIA-KMCO.fms
-
thanks