Greetings,
I just purchased this aircraft and so far I'm really impressed of this product.
I do have one issue though that I can't seem to figure out:
When going through the "Getting started" tutorial, everything works as expected, but if I try to start the aircraft without the tutorial, I the ITT temperature rises too high immediately after I move the throttle from "Cut off" to "low idle" (When I do this, NG is above 13%, ITT is below 150C, and I've waited ~10 seconds from ignition start).
I've repeated this at least 5-6 times now, with a new airframe each time. It always works to start the engine if I'm doing it through the tutorial, but I never succeeds if I'm not running the tutorial.
I did read in another post that moving the throttle prior to starting the engine could cause this fault, but I've made sure to unassign my throttle quadrant due to the noise it makes (the quadrant from Saitek/Logitech), but that didn't solve my issue.
Any help appreciated
Regards,
Erik