Fuel Selector after update

[JGregory]

Sorry I somehow reposted my last post. I bought both the Dash 8 and the Challenger 300 jet on the same day and confused the two: it is the Challenger 300 that requires removal of Gizmo in order to run. Sorry.

I restarted X-Plane and used the Plugin Administrator to see what plugins loaded. I found only one jgxC400v1.2 but think in the past I might have seen two? Anyway, the brakes are now working again and the PDF is back to normal. I may not have restarted X-Plane after reinstalling the C400 v1.3, that's all I can think of. Thanks for your help, I now look forward to flying my favorite GA aircraft again!

Wait!... you should have JGXC400v1.3, not v1.2... are you sure that is right?

[dklxplane]

jgxC400v1.2 appears in the Plugin Admin-Enable/Disable menu in X-Plane. The plugin in X-Plane:Aircraft:X-Aviation:Cessna Corvalis TT:plugins:JGX_C400v1.3:mac.xpl is dated 5/9/11. There are no older Corvalis TTs in my X-Plane folder (there were earlier yesterday.) There also are no Corvalis plugins in the Resources:plugins folder. Is the 5/9/11 plugin incorrect? If so, how can I get the new one?

[JGregory]

jgxC400v1.2 appears in the Plugin Admin-Enable/Disable menu in X-Plane. The plugin in X-Plane:Aircraft:X-Aviation:Cessna Corvalis TT:plugins:JGX_C400v1.3:mac.xpl is dated 5/9/11. There are no older Corvalis TTs in my X-Plane folder (there were earlier yesterday.) There also are no Corvalis plugins in the Resources:plugins folder. Is the 5/9/11 plugin incorrect? If so, how can I get the new one?

Sorry, that is my fault... I forgot to rename the plugin signature when I compiled version 1.3. It sounds like your setup is OK. In any event it appears that everything is working for you at this point. If you have any further problems please let us know.

Regards,

Jim