AF380 Posted July 5, 2013 Report Share Posted July 5, 2013 Greetings! =D I recently purchased the JAR A320, and might I say it is well rendered and accurate. I enjoy flying with it on small 1-2h flights. Small question though, how do you input a a route into the FMC? so far ive been flying basically with sight and using landmarks. though ide like to start using the plane in VATSIM but cant figure out how to use the FMC. Also I don't know where the transponder box is (Sqwak code input). I have done a little searching in forums and youtube but most only show flights underway. The panel on this plane is much more different then the previous panels i have seen. does anyone know how to do either of the two? Quote Link to comment Share on other sites More sharing options...
BWolf7 Posted July 5, 2013 Report Share Posted July 5, 2013 You realize that the plane is not sold here, so you should go to the store that you bought it from for support. I can tell you, that it is in the lower right pedestal. Also consult the manual. Quote Link to comment Share on other sites More sharing options...
AF380 Posted July 5, 2013 Author Report Share Posted July 5, 2013 ok thanks thought i would at least see what would happen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.