Help with the autopilot and a minor issue.

[ArturoJGT]

Estimados. 

1- I'm unable to activate the AP. The plane is leveled, there are no warning lights, HDG and IAS are activated, and the yaw damper has a green light. However, when I press the AP button, two-tone chimes go off, and there is a momentary green light in the AP switch, but nothing more than that. The roll knob is centered.

2- The main configuration windows in 2d are not showing, only in VR.

 

Edited December 26, 2024 by ArturoJGT

[ArturoJGT]

1- There are a few requirements for AP to be able to engage:

• The "Turn" knob must be centered on the AP control panel on the center pedestal. There is a clickspot on the knob that will center it for you as well.
• The attitude gyro must not be in fast erect mode. This is the lower left switch on the pilot's switch panel located to the left of the main pilot's displays
• The ATT2 gyro must not be enabled as the EADI source. This is the button underneath the DME power button on the pilot's panel. "ATT2" would show on the EADI if it is selected. 
• The ATT1 gyro must be aligned. (If you see the horizon bars on the EADI, it is aligned)

 

2 ?

[Coop]

What you posted above are the requirements for AP engagement. If it still isn't working, please send your log.txt file and screenshots showing both the EADI and the AP center pedestal.