GA and CWS

[hspaceee]

Hi, is the current implementation of the go around mode correct? If I click it using the "ga_throttle button push" command I get the behavior shown in the image above, with no flight directors. If I use the xplane built in "activate go around" command the autopilot automatically engages (taking control from me) and commands about an 8-10 degree pitch up. Neither of those seem to be the expected behavior, though I'm far from an expert on this aircraft.

 

Also, am I correct in assuming the black button on the left of the pilot side yoke is supposed to be a control wheel steering button? Binding the command associated with it "afm/cj/cmd/p_yoke/ap_trim_toggle_PUSH" temporarily turns off the autopilot, but does not sync the flight directors when it's released. Is this also correct behavior?

 

Thanks!

 

 

[Coop]

Both are being looked into