IXEG 737 Classic Plus won't move with application of thrust (Yes, engines are running and brakes are off)

[Technophobepilot]

I'm very new to x-plane so there’s a good chance I’m doing something dumb.

I’m using x-plane 12 with Thrustmaster yoke and throttles with the IXEG 737 Classic Plus aircraft.

When I’m lined up, aircraft configured, FMC set, engines running and spooled up to 100% N1 and brakes released the aircraft does – absolutely nothing – won’t move.

Anyone have any ideas what might be going on here?

 

An additional question; is it possible to use the rotatable knob on the thrustmaster controls to interact with multiple aircraft knobs – IAS, HDG, ALT, Radios etc? If not, I’m open to suggestions. Using the mouse to do this is a pain.

[Cameron]

Do you have XPUIPC installed? It's known to cause this issue. The solution is to find an older version of XPUIPC, or remove it completely. Unfortunately, the developer of that plugin hasn't been around for some time.

10 hours ago, Technophobepilot said:

An additional question; is it possible to use the rotatable knob on the thrustmaster controls to interact with multiple aircraft knobs – IAS, HDG, ALT, Radios etc? If not, I’m open to suggestions. Using the mouse to do this is a pain.

Yes, you can assign these in the joystick configuration area. Just do a search for IXEG in there and you'll find commands pop up.