Quick Look view problems

[rogo2021]

I hope someone can help as I cannot fly the MU2 until I resolve this problem

I have posted here because I don't have the problem with other aircraft.

All was well until I decided that some Quick Look views would be helpful.  I have set up a few and they are assigned to buttons on my Honeycomb yoke.

Unfortunately every view has the same problem.  The initial view is the one I chose but then immediately the view begins slowly sliding downwards.  Each view is the same and even using 'w' is affected.  It doesn't matter whether I use the buttons or the keyboard - same problem.  I thought for a minute I had found the culprit - Ctl+down, but not so.

Any ideas appreciated - I have looked through all the pages here, but nothing found.

[Ch.Cole]

Did you doublecheck your button assignments to make sure there's no button or switch assigned to move the view?

[rogo2021]

Hi,

Sorry for the delay in getting back to you.  Yes. you are right, that was the problem (as it so often is).

All is good now.

Thanks,

Roger