Jump to content

Recommended Posts

Posted

After a complete reinstall of the Mu-2 yesterday i cannot get the ghost throttles to display under any of the condition options (Always, Lift Zone and Below, nor When Out Of Sync).

Any ideas?

Untitled.png

Posted

in your first screenshot,  your "auto-stop power levers at detent" is not checked and the ghost throttles will not show in that situation.  In the second screenshot series, you do have this checked;  but your visibility is set to 'lift zone and below" with upper limit at 0.6...and your torque meters indicate that you're probably not in that zone. So both of your screenshots are configurations where i would not expect the ghost throttles to show..

Check the box "auto-stop power levers at dentent and then set the visibility to 'always' and see if they show for you then.

TK

Posted
10 hours ago, tkyler said:

in your first screenshot,  your "auto-stop power levers at detent" is not checked and the ghost throttles will not show in that situation.  In the second screenshot series, you do have this checked;  but your visibility is set to 'lift zone and below" with upper limit at 0.6...and your torque meters indicate that you're probably not in that zone. So both of your screenshots are configurations where i would not expect the ghost throttles to show..

Check the box "auto-stop power levers at dentent and then set the visibility to 'always' and see if they show for you then.

TK

The second Series was my Answer to the Original Poster. I do not have Problems with the Ghost Throttle. Worked perfect for me. The OP did not respond yet if his Problem is solved.

Posted (edited)

@meierzwo I'm super sorry about that.  I answered that while 'on the road' visiting my elderly mom and wasn't really paying close attention.  Thank you for responding to the original poster!

-tk

Edited by tkyler
  • Like 1

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...