Shutting down the engines

[Goofy]

Hello   
According to the checklist provided, to stop the engines we should normally use the RUN/CRANK/STOP switches in the STOP position for 3 seconds and put the power controls on full reverse.
However, the RUN/CRANK/STOP switches do not stop the engines (these switches have only two positions). To stop the engines, we have to close the MAIN fuel valves or put the Condition Levers in the EMER STOP position.
=> Is this the expected functioning ?

[MANOLO]

No.

A third position of switches  to STOP engines can be found if you point the mouse cursor below them. An arrow pointing down will appear and you can stop the engine correctly.

[Goofy]

Ok, thank you. I will look for that   

[Goofy]

Okay, I've figured out how it works. The RUN/CRANK/STOP switches must be first in the down position for this click zone to be active.

Edited May 24, 2023 by Goofy