Goofy Posted May 24, 2023 Report Share Posted May 24, 2023 Hello According to the checklist provided, to stop the engines we should normally use the RUN/CRANK/STOP switches in the STOP position for 3 seconds and put the power controls on full reverse. However, the RUN/CRANK/STOP switches do not stop the engines (these switches have only two positions). To stop the engines, we have to close the MAIN fuel valves or put the Condition Levers in the EMER STOP position. => Is this the expected functioning ? Quote Link to comment Share on other sites More sharing options...
MANOLO Posted May 24, 2023 Report Share Posted May 24, 2023 No. A third position of switches to STOP engines can be found if you point the mouse cursor below them. An arrow pointing down will appear and you can stop the engine correctly. Quote Link to comment Share on other sites More sharing options...
Goofy Posted May 24, 2023 Author Report Share Posted May 24, 2023 Ok, thank you. I will look for that Quote Link to comment Share on other sites More sharing options...
Goofy Posted May 24, 2023 Author Report Share Posted May 24, 2023 (edited) Okay, I've figured out how it works. The RUN/CRANK/STOP switches must be first in the down position for this click zone to be active. Edited May 24, 2023 by Goofy Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.