Minor Issue with RH Run/Crank/Stop Switch Animation & Sounds

[sardilli]

The RH Run/Crank/Stop animation and sounds seem to change behavior after using the shutdown keyboard bindings. This can be recreated with the following steps:

1. Start aircraft cold and dark
2. Move the RH Run/Crank/Stop switch; the switch correctly "lifts" on mouse button down and "lowers" on mouse button up.
3. Toggle the engine keyboard shutdown binding (either both or RH only bindings results in the same behavior described below)
4. Move the RH Run/Crank/Stop switch again; the switch now no longer lifts and the sounds stop working

Note that this does not impact the actual shutdown behavior, just the switch animation and sound. Also the LH switch is fine and does not exhibit this behavior.

Thanks in advance!

[sardilli]

Additionally, is it possible to shutdown the engines using the mouse? I have only been able to get the switches to move below "crank" using the keyboard binding.

[tkyler]

11 hours ago, sardilli said:

Additionally, is it possible to shutdown the engines using the mouse?

It is..there are click spots just below the switches.  3 of them, one under each switch and one in the middle to hold "both at once"  If you hover the mouse just beneath the switches, you should see the cursor change.

-TomK

[sardilli]

Got it, thanks. Found the click spots and they shutdown the engines as expected. However, the RH switch still seems to exhibit the same behavior I described after using the click spots as it did using the keyboard binding (switch now no longer lifts and the sounds stop working).