heading bug only turns to the right

[rudder3]

Hello.... the heading bug only will go to the right,, don't matter which side of the lower right knob your little arrow is on it only will change to the right... thanks

[rudder3]

Hello.... the heading bug only will go to the right,, don't matter which side of the lower right knob your little arrow is on it only will change to the right... thanks

[Coop]

Hi, I just loaded up to double check, and I can't replicate that behavior on my end.

• Are you using the G5 in the 3D cockpit of an aircraft (if so, which one) or are you using the popups?
• Are you using clicking or the scroll wheel to a adjust the knob?

[rudder3]

Hi Coop from Torquesim....  Using it in a C172 ..  I have used both clicking and wheel .. this is not a popup but a panel mount I bought from you I think.. are you AMF or sale there products?  most of the time if a power it off by master switch it will run ok for a few minutes... Real pain if on pilot edge and they give a heading with left turn. you have to turn of auto pilot ...

Different issue..   I bought two SR20 (g1000 and Avidyne ) and they will not follow the GPS in "Leg" mode.  Get to the point to turn and up top where its a green GPS it just goes blank..  Then wait a few seconds and hit "Nav" and it will make the turn on its on toward next waypoint,,   

thanks very much for the reply Coop

Edited December 16, 2021 by rudder3

[Coop]

Hi Rudder, we haven't heard either of these issues reported before nor can I replicate them, so I'm guessing there is something conflicting on your system. Can you send the log.txt file? You can find a guide to get this file here: 

How to find the X-Plane log.txt file?