Request to add more commands for the fuel pump switch

[momix2000]

Hi,

I'm building a cockpit for your amazing sr22T.

I have a request if it's possible.

do you mind to add 3 different commands for the fuel pump switch?   prime , no pump and boost?

I would like to use a 3 positions switch to change the settings but with the corrent commands i cannot controll  the position ( i'm flying only without the virtual cokpit)

I have tried using the dataref  "afm/sr/f/switches/fuelPump" but aparently I cannot write it properly. I'm using air manager.

It change the position for a fraction of a second ( i see the animation) but then it reset itself.

thank you for your time and help.

best

 

Edited March 16, 2021 by momix2000

[Coop]

If you can write to a dataref, try writing to afm/sr/switches/fuelPump, most of the datarefs with /f/ are not writable as they are the smoothed animation dataref that follows the parent dataref.

[momix2000]

thank you Coop for the suggestion. I will try and I will report.

best!

 

[momix2000]

Hi Coop,

I checked and unfortunally there is no such dataref :  afm/sr/switches/fuelPump

i also checked under afm/sr/switches/ but non fuelpump is present

i have found the tankSel that is useful for another switch but nothing to controll the fuel pump.

are you sure that this dataref is present?

thanks!

best.

 

EDIT: I tried also to write to afm/sr/switches/tankSel to controll the switch of the fuel selector  but it doesen't work..... maybe something is wrong...

 

Edited March 17, 2021 by momix2000

[Coop]

Our datarefs aren't published explicitly to DataRefTool, they are to DataRefEditor (or through DataRefTool if ran in the DataRefEditor emulation mode).

afm/sr/switches/fuelPump and afm/sr/switches/fuelSelector are the datarefs for the fuel pump switch and fuel selector, respectively. 

[momix2000]

AWESOME! :-) now the fuel selector and fuel pump works. the only remain problem is with the flaps.

I'm using " afm/sr/switches/flaps" but i cannot write it.

I'm so sorry to bother you so much but do you have any extra idea?

thank you very much!

Carlo

 

[Coop]

Using the default flap commands is best for the flaps.

[momix2000]

Ok. I will figure it out!
thanks again for all your help!
Waiting for the next update of the Cirrus.

Best GA on the market!!!