Aileron trim not working

[DContreras]

I have uploaded version 1.01.  The aileron trim on the stick works, but does not animate on the control stick and there is no corresponding noise for it.  Without this, it is practically impossible to assess whether the trim is properly centered during run-up.  Found this out the hard way when the plane banked hard to the right after take-off.  On the external camera view, I can see the trim move, but to get it lined up properly is extremely difficult and impossible during flight.  Without the animation, you cannot test the AP in the preflight phase.  I saw another video on one of these threads and the person commented about the trim not showing on the original release.  

[DContreras]

This is the video where the aileron trim not working was mentioned:  

 

[wired521]

I've noticed this as well,

In the interim, there is an aileron trim reset control you can bind (default is 9 I believe). I've been using that as a work around for the time being. 

[DContreras]

Just now, wired521 said:

I've noticed this as well,

In the interim, there is an aileron trim reset control you can bind (default is 9 I believe). I've been using that as a work around for the time being. 

Thank you for the information.  I will give it a shot.

[Attitude]

Visually inspect the ailerons outside to confirm you are centered. The side stick system has been fixed on my end and will be in the next update. 

Edited August 13, 2020 by Attitude

[DContreras]

On 8/6/2020 at 7:49 PM, Attitude said:

Visually inspect the ailerons outside to confirm you are centered. The side stick system is has been fixed on my end and will be in the next update. 

Awesome!  Thank you for the response.