Red Crosses pfd and g1000 display

[Captain744]

Hello there, After completing a successful circuit and 1st landing the plane was successfully shutdown saved in xplane and then revisited about 30 minutes later. On turning on the crash bar and battery Iv now discovered my prop rpm,ng,itt, comms and navs display all have a Red Cross over them. Can anyone tell me why this is? What did I miss? (No faults reported in maintenance) This happened in the x-plane beta once before so I reverted back to the latest non beta version, (created new airframe )thinking this was down to a conflict with the beta. 

Many thanks 

Lee. 

Edited November 30, 2018 by Captain744

[cromsan]

I have the same problem with Xplane 11.32 and with the last dowloading of the TBM900, 1.1.6.

Thanks.

cromsan

[Shinjo]

Check out this thread and see if this is the same issue. If so it's because something is incorrectly setting the avionics dataref to 0. In my case it was my Saitek panel.