Jump to content

Recommended Posts

Posted

It's just a doubt with the oil pressure level ok, I see that it never drops to 0 the pressure level, it's always between 9-10.
Is this oil pressure correct?

Note: My doubt arose when I saw a cold start of this TBM900 Real and the oil pressure was 0. :huh:

Posted

It comes down to wind and if the engine is windmilling. Any small rotation of the compressor can turn the oil pump and produce a little bit of residual oil pressure. That having been said, I know there a little bit of fine-tuning we can do at the very low engine rpm bands to get the oil pressure all the way to zero. We'll look into this later down the line.

Posted (edited)

thanks for your reply : skiselkov :)

NOTE: short video of the engine in cold and with the protection of the propellers for any type of rotation by the wind.

 

Edited by Xpillo
Posted (edited)

HI, Tonight I started a new flight with the TBM900 and my surprise was when looking at the oil pressure, not understanding well what happened, but now it shows well the oil pressure = 0/1..... I went crazy or what happens?? :o  

EDIT: I have been able to verify that eliminating the winds in the weather conditions setting the oil pressure is set to 0-1. Therefore the oil pressure data is linked to the winds.  Any wind existence the oil pressure shows between 9 -10-12 etc … this is how the oil pressure is simulated with weather conditions. B)

 

TBM900_2.png

 

Edited by Xpillo
Winds + oil pressure 8 )

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...