No Thrust on Engine 2

[mga010]

Today, I get a strange problem. Even though the engine has started properly, moving the thrust has no effect on engine 2. Only number 1 gets thrust. There is also unsymmetric oil quantity, and the pressure is not in the green. I have not set any failures. Start was from turn around. Probably a technical problem from my side, but which?

Paul

[Litjan]

Hmm, let me guess, you are using XP11 and you are not reading many forums related to XP11, right?

Here, let me help you with that:

http://forums.x-plane.org/index.php?/forums/topic/110304-ixeg-737cl-and-more/&page=2#comment-1134164

 

Edited March 6, 2017 by Litjan

[mga010]

I saw this thread before I bought the plane. It has grown since then.

Anyways, I did not have problems with the plane besides this issue. Maybe this problem is related to the fact that I "resumed last flight". Or to the turn around state. Will check.

[mga010]

I now did it from turn around, and the problem did not reappear. Had some other problems, though, but not in this thread.

[smoothchat]

Do you have the ground handling plugin installed. 

I have found that the IXEG 737 doesn't like that plugin.

If I remove it, I cannot get one engine to fail as you describe,  yet every now and then it "does" fail if I have the ground handling plugin installed.

 

I believe that the pause introduced as groundhandling initialises, highlights the issue with the idle (as covered in the posts above)

Edited May 11, 2017 by smoothchat