Jump to content

Pixel of Life

Members
 View Profile  See their activity

  • Posts

    5

  • Joined

  • Last visited

Pixel of Life's Achievements

Newbie

Newbie (1/14)

  • Conversation Starter Rare
  • First Post Rare
  • Dedicated Rare
  • One Month Later
  • Week One Done

Recent Badges

0

Reputation

  1. Pixel of Life
    Yes, I have the public beta channel selected on Steam. Log.txt says X-Plane 12.2.1-r1-ab13dbf0.
  2. Pixel of Life started following Landing performance card & AoA indexer disagree
  3. Pixel of Life
    I've noticed that when the AoA indexer shows that I'm on speed, my IAS is around 10 knots slower than the Vref shown on the landing performance card. Shouldn't the green circle AoA correspond to Vref?
  4. Pixel of Life
    Thanks. How would one handle this in real life when piloting a C525 with this setup? Is it acceptable to use the GTN to drive the autopilot even though it doesn't follow the route exactly, or should it be used for monitoring only while the UNS steers the plane? Presumably the GTN isn't certified for certain procedures because it's not precise enough?
  5. Pixel of Life
    When using the GTN 750 as the autopilot nav source, it overshoots even shallow turns and has to correct to get back on course. As far as I can remember, the UNS-1 doesn't do this. Not sure if this is an issue with the plane or with the GTN, so I'm asking here first.
  6. Pixel of Life
    Pixel of Life changed their profile photo
  7. Pixel of Life
    More information about ""
    Thanks, these look great. A couple things though: First, the fix posted above (and included in the newer version of the mod) only changes the color of the nav light billboard, but not the color of the actual light that gets cast onto the ground and other objects; that's still green even though the light itself appears red. In order to fix this, open the Winglet_Lights.obj file in a text editor, and on the row that has "airplane_nav_sp" followed by a NEGATIVE number. It should be line 13. On that line, find the three values that go "0 0.85497922 0.00035693203" and swap the first two values so it goes "0.85497922 0 0.00035693203" instead. Then save the file. Second, if you're bothered by the original nav and strobe lights shining through the winglets, they can also be removed. Go to the plane's objects folder and open EXT_LIGHTS.obj in a text editor. Around the middle of the file, you'll find ten consecutive lines that start with "LIGHT_PARAM airplane_nav" or "LIGHT_PARAM airplane_strobe". These should be lines 47-56. Insert a # symbol at the start of each of the ten lines to comment them out and then save the file. Note that you may have to do this again any time the plane gets updated.
×
×
  • Create New...