Jump to content

rbandz

Members
  • Posts

    10
  • Joined

  • Last visited

rbandz's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. So, there was a circuit breaker that popped out. I don't know how or why. GCU 1 was popped out. Everything seems to be working now. Lastly, does this page for AC Electric look fine? anything jumping out to you as wrong? I would love to get in the air if this is all good now. Thank you
  2. Negative, I believe this is some electrical error. I have GEN 1 on, APU GEN on, and GEN 2 on, however only GEN 2 is outputting. Picture of outside and also of display showing AC Electrics
  3. Yes, even with APU GEN on, I can only get generator 2 to activate. ESS POWER button stays on ALTN, and AC/DC utility stays on off.
  4. What is the procedure for getting my electrics working? I've run into this error and dont have any info on how to go about fixing this. ESS BUS alt, gen 1 off. Thanks
  5. That was it, my 14 stage on bleed panel was the culprit. Solved, thanks again
  6. Hopefully you can tell, in this picture, the reverse lever is up, activated by command 'hold thrust reverse at max #1' - but you can see the gauges the plane is actually not going into reverse and instead the engine is spooling up with forward thrust.
  7. I am just on the apron before take off testing all the controls making sure it is working with my hardware. Engines are on, throttles at idle, and when I active the reverser on my throttle (HC Bravo) I see the reverse lever lift up in the sim, but instead of going into reverse and indicating REV on the gauge, the engine spools up and gives forward thrust. I do not understand what you mean by "unlatched" and perhaps that is where I am messing up. Thanks
  8. What are the preferred binds to engage reverse thrust? These usually work for me, however they do not engage reverse on the Challenger. They actually increase engine thrust even though I do not move the throttle axis. Thanks
  9. I am having an issue starting the APU, I keep getting PUMP FAIL & SOV CLOSED errors. I do not know how to get the pump back and re-open the valve. What I think caused this: I turned on the battery, and APU, and then shut the plane off in order to enter my simbrief details in the "User Settings" section of the menu. When I went to get everything back on, this had happened. I was requested to post to the forums about this, I do not actually think it is a bug, but I have posted it here anyways and will wait for a response. Thanks
×
×
  • Create New...