Bluedleta737

Ever since I got the new update and I'm at KPHX airport when ever I set the altimeter over 3010 Hg then the altitude alert will go off and wont stop blinking till I bring the altemiter setting below 3010.

nvm I got it

I see it and can click onnit but how do I actually activate it?

For the IXEG 737 FMC it says it is using a VERY old outdated AIRAC. IS there anyway to update this with navigraph

Ya I use that method now and I just totally ignore the T/D mark to be quite honest.

Thanks I did get the email and got the update, pretty good and I noticed some of the reflection detail!

I checked the email I got when I downloaded the plane but it doesn't say anything about updating it....

So I heard that a new update recently came out for the plane fixing a few things, so how do you update it? Or does it update automatically?

Alrighty thanks

Alright thanks, I asked because the T/D mark is still buggy and appears way to late in my flight plan...

So this is a dumb question, but how do you actually tell how far you are from your destination airport?

So what would be the V/s speed for this formula to work, or would you just use VNAV?

So if I was cruising at FL370 I would divide by 3.7 to get 100 or divide by 3.3 to get 112?

So what would be considered a "simple route"

So I have a flight planned from KPDX-KABQ. everything is good except for the T/D mark which is shown way too late in my route. It wants me to start descent like 20nm from the airport and I'm cruising at FL350. I don't know what is up with that because at some airports the T/D mark is fine...